kahrnut1
12-29-2011, 12:11 PM
i just got through dissasembling 9 pm & cw mags and found that on 2 of them the end of the mag spring where it is bent in towards center was bent to far and was causing the side of spring to drag on inside of mag
body. have not seen this listed before on this site all you have to do is bend end of spring back out a little bit and it is good to go. of the 9 mags 5 followers wre hitting mag lock and would not drop in without spring. a little sanding and good to go. 2 6 round mags had rough feed lips used 600 sandpaper wrapped around 3/8" dowell and are smooth to touch.:)
body. have not seen this listed before on this site all you have to do is bend end of spring back out a little bit and it is good to go. of the 9 mags 5 followers wre hitting mag lock and would not drop in without spring. a little sanding and good to go. 2 6 round mags had rough feed lips used 600 sandpaper wrapped around 3/8" dowell and are smooth to touch.:)