potential issue after removing/replacing mag release

[titus1971]

I love my CW45 and I have had 0 issues since I purchased it. The IWB holster I carry it in doesn't cover the mag release button and the ridges on it dig into my side when sitting. I took the mag release out and hand sanded the ridges down a bit. I put it back together and now about 30% of the time when I rack the slide the round gets about 3/4 of the way out and then something binds it. If I remove the magazine then it hand racks fine. I've disassembled/reassembled it several times and I cant see anythign obvious. I havent shot it since the reassembly. The mag catch and spring are fairly straight forward, what could possibly have happened to cause this and more importantly, how can I fix it?

[titus1971]

Well when I got home I ran a couple mags through her and it seemed to feed, fire, and eject just fine so whatever the issue that causes it to give resistance when hand racking/ejecting doesn't seem to affect operation. I'm going to try to get to the range soon and run a hundred or so rounds through it and see what happens.

[Cokeman]

Why didn't you sand the mag release without taking it out?

[MW surveyor]

Probably because he was concerned about digging into the grip?

[titus1971]

Probably because he was concerned about digging into the grip?
That's exactly why, i didnt want to damage the frame. Since the CW45 mag release is all metal it required a little mojo to knock the edges down.