PM9 Extractor Front Pin question

[PM9Jon]

I am new here to Kahr Talk, so I would like to drop a question upon those who are "in the know" about Kahr and parts and whatnot.

I seemingly lost the extractor front pin on a "new to me" Kahr PM9 while I was detail stripping the slide. (oil, grease , crud EVERYWHERE)

Will the extractor front pin from a CW9 be the same one as the PM9?

Any good places to grab a front pin?

Thanks

[jocko]

yes
I know of no placeother than kahr to get it......
if ur gonna order it from kahr, then order the PM pin just to be 100% sure.

[PM9Jon]

anyone have a ballpark on how long it takes to ship to florida or somewhere near?

I'm disassembling my CW9 at this moment to get the PM 9 up and running lol

is the slide stop supposed to spin on the PM9, because it doesnt in the CW9

also...are these parts MIM or real steel

[gb6491]

The "P" series stops are three piece affairs (two pins and lever); it's not unheard of for the big pin ("real steel") to spin. The "C" series stops are one piece MIM parts.
Regards,
Greg

[wyntrout]

It shouldn't take more than a week to get parts.

The P380 has smaller parts... extractor, front pin, spring, rear pin. All of the larger Kahr polymer pistols have different extractors, though some like the P9 and PM9 seem to be interchangeable... I used a PM9 extractor in my P9 with no problems.

All of the larger Kahr polymer pistols use the extractor springs, front pins, and rear pins... EXCEPT for the .45's... which use larger REAR pins.

The slide locks may or may not have pins that spin. Either is okay... two designs... one's cheaper.

Wynn:)