Harrylee
12-31-2012, 10:45 AM
Had my cm9 for about year now nice little gun the first thing I just could not get used to was the rear bar sight I tried getting used to it but could not, too many years with 3 dot so I called kahr and asked if I could flip the rear sight 180 they said yes you just need to make sure you take it out the correct side of the slide one side is a little wider than the other
It was a pretty tight fit so I took it back to the dealer I bought it from and he pressed it out for me. From there I took it back to my shop vised it up and on the other side from bar sight got my dremel out with a small diamond round bit and carefully put two small dots on it, once that was done put a little white lacquer in the dot holes reinserted the sight in slide, tap in with brass punch made sure it was centered
Made world of difference to me
Cost of modified rear sight $0
Thought I would pass this on good luck
It was a pretty tight fit so I took it back to the dealer I bought it from and he pressed it out for me. From there I took it back to my shop vised it up and on the other side from bar sight got my dremel out with a small diamond round bit and carefully put two small dots on it, once that was done put a little white lacquer in the dot holes reinserted the sight in slide, tap in with brass punch made sure it was centered
Made world of difference to me
Cost of modified rear sight $0
Thought I would pass this on good luck