CW9 and Blazer Brass 9mm

[gonewinchester]

Has anyone had any issues with the CCI Blazer Brass rounds in there CW9? Thinking about getting some and was wondering about accuracy and consistency?

[b4uqzme]

Has anyone had any issues with the CCI Blazer Brass rounds in there CW9? Thinking about getting some and was wondering about accuracy and consistency?

That's mostly what I shoot thru my mk9 if that's helpful. Lowest cost brass I can consistently find. No issues. I don't think you can go wrong with any factory brass. But each gun tends to have its own idea about that.

[b4uqzme]

BTW. where'd your Winchester go? :rolleyes:

[gonewinchester]

Threw the barrel...haha

[b4uqzme]

That happens. ;)

As for accuracy: any brass seems more accurate than me. The only range ammo that has been noticeably more accurate (for me) is Sellier & Bellot 115gr FMJ. That could just be my perception.

Welcome!

[b4uqzme]

Threw the barrel...haha

Maybe I should change my forum name to "gone7iron". Just sayin'.

[nuke]

I've shot a lot (probably want to say at least 300 rounds) of the CCI Blazer Brass thru my CW9 and I believe I still have some on-hand. No issues.

[rjt123]

I preferred Blazer regular/aluminum ammo for range fodder. That was back before you would shoot anything you could actually find/buy. I've never had any trouble with that ammo in any calibre I shoot (.380, 9mm, .38 Special/.357, .45 ACP). I even think highly of CCI's .22LR stuff (Stingers, Mini-mags, etc).

Never had any trouble with feeding on any of my Kahr or Ruger handguns. I've shot a lot of Blazer Brass too, and it works just as well. I don't reload, so the casing (aluminum vs. brass) makes no difference to me.

[xsailer]

I'm shot several boxes thru my cm9 and M&P9c with no problems at all. Bought them at Gander Mountain but haven't seen them there since.

[jocko]

its great ammo buy it, and shoot it like u stole it....

[rjt123]

its great ammo buy it, and shoot it like u stole it....

Once again Jocko cuts to the essential, simple response. :)

[addictedhealer]

Yet to find ammo my cw9 won't eat, and I have shot some ammo that was just....terrible.

[yqtszhj]

buy it and shoot it. I have probably 1000 rounds on hand and have shot about that much too. I have never had one problem with a single round of this ammo.

[LorenzoB]

Blazer brass or aluminum... They both run great through all my guns.

[kwh]

125 gr. perfect. 115 gr. not so well when CM9 was new.

[berettabone]

I use it in .40 cal in my Beretta.......................used some for breakin on my Kahr MK9.....had 3 fte's, and that was after 150rds. of Fiocchi. No problems with .40 cal. but I prefer the Fiocchi.......dirty, but more snap.....................

[skiflydive]

I ran 50 Blazer Brass through my CM9 last week and, without cleaning the gun in between, another 50 today. Every round went bang just like it's supposed to and the gun cycled perfectly every time. It doesn't seem to be any dirtier than anything else I've run through it... no brass flakes or powder chunks. It's good for me.

[gonewinchester]

I have shot about 150 rds of it threw my gun now and it works just fine. Thanks for the response though

[luvall]

All I use and never a problem.

[muggsy]

To me Blazer Brass is dirty ammo. It's cheap, but will function in most guns. Not my personal first choice.

[jocko]

I shoot blazer CB 9 ammo

CB = clean burning kinda hard to find.It has a lub that actually lubs my rails to and cleans the striker channel. good stuff. kinda hard to find.:behindsofa: