I need a picture of inside the frame.

[Dirty Harry]

I'm getting the silver parts on my CM9 Cerakoted black. I had to strip the frame to get the trigger out. I couldn't find any videos on how to do it so I decided to go for it. It wasn't hard at all. Unfortunately I didn't pay attention to how the spring was wound on the trigger.

If someone would be so kind as to remove the slide and take a high resolution picture of how the spring is wound on the trigger I would really appreciate it.

Pleas email it to HondaTRX450Racer@aol.com

Once I figure out how to reassemble it I will post a video on how to do it.

Thanks

[RevRay]

I sent you an email pic. Not sure if it will help or not.

[gb6491]

There's a drawing of how the spring is oriented towards the bottom of the page here: http://www.gunreports.com/special_reports/handguns/Kahr-Pistol-Disassembly184-1.html
You might also find this thread of use: http://kahrtalk.com/showthread.php?t=4454
Regards,
Greg

[Dirty Harry]

I sent you an email pic. Not sure if it will help or not.

You are the man!! I got it.

Tomorrw I will make a video of tear down and reassembly of the frame.

It's very simple.

[Dirty Harry]

There's a drawing of how the spring is oriented towards the bottom of the page here: http://www.gunreports.com/special_reports/handguns/Kahr-Pistol-Disassembly184-1.html
You might also find this thread of use: http://kahrtalk.com/showthread.php?t=4454
Regards,
Greg


Thanks Greg.

RevRay's picture did the trick.