Kahr recoil spring problem?

[Kajuken]

Hello
Im Form to Spain, It is not to write very well in English. I have a kahr pm9, have problems on having mounted it, spring stays it was like in the photography and also the slide stays com in another photo. Have I to replace the recoil spring?


http://http://njgunforums.com/forum/index.php/topic/27770-kahr-cm9-issues-range-report/

Thanks

[Kajuken]

The photographies are in this page:

http://njgunforums.com/forum/index.php/topic/27770-kahr-cm9-issues-range-report/

Thanks

[berettabone]

Looks like you put the spring on incorrectly.........................

[jocko]

the open part of the coil spring is normally ut in with the open end facing the top of the slide. Nuttin wrong with your gun, u just didn't get it backinb correctly.

[gb6491]

the open part of the coil spring is normally ut in with the open end facing the top of the slide. Nuttin wrong with your gun, u just didn't get it backinb correctly.
+1:hippie:
http://i39.tinypic.com/2l9qq0i.jpg
Regards,
Greg

[Kajuken]

The photos are equal to what it goes on to my kahr. I have put well spring as it says in the instructions.

[Kajuken]

+1:hippie:
http://i39.tinypic.com/2l9qq0i.jpg
Regards,
Greg

Ok...I go to do what you say: 12 o clock... Thanks

[Kajuken]

I have put the spring at 12 a.m. or clock and it does not serve, I have problems on having put the slide, it does not come behind completely. Spring in his part opened already does not go out.

[gb6491]

73J64X1WhuY

[jocko]

count the coils on the outter recoil spring. there should only be 13coils, not 15. what GB6491 ask of u to do is good advice to. Open thatyoutter coil up a tad.

[Kajuken]

I have 13 coils....

[Kajuken]

73J64X1WhuY

Ok...thanks! But doing like in the video, the sliding panel has problems to go backward and to be able to insert slide stop sign.

[gb6491]

Ok...thanks! But doing like in the video, the sliding panel has problems to go backward and to be able to insert slide stop sign.
Just push the slide/barrel back far enough to align the barrel lug with the hole in the frame (you might have to manipulate the barrel as well):
http://i40.tinypic.com/b49e6t.jpg
Insert the pin about 1/2 to 3/4 the length of the pin and rotate the lever to three o'clock:
http://i44.tinypic.com/28kijx2.jpg
Push the slide back to align it with the slide stop lever; then, making sure the spring is above the shelf on the lever, push the slide stop into position:
http://i40.tinypic.com/2i0tet2.jpg

Note: you may have to pull the trigger to get the slide to go far enough rearward for some of the steps above. I have to on my CW45;
41einZaqxVo

Regards,
Greg

[Kajuken]

Ok
my kahr passes your CW45 like, but I have tried the same as the video but I have no results. I have that attachment and detachment, touching the spring until it lets me ride the slide

appreciate your help

Thanks