Scott55
02-13-2014, 06:04 PM
Picked up my new CM9 from my local dealer a couple weeks ago.
Been to cold shoot outdoors the last two weeks.
I read over the prep threads and noticed I was getting the hang up on the magazine follower when inserting the spring and follower. Sanded it with some 600 grit as described in the prep thread.
Field stripped it, cleaned and lubed it per instructions. I also racked the slide at least a couple hundred times to help break in the spring.
So today the Sun was shining and it got to 34 degrees and we plowed out the snow so we could get to our range.
I put 150 rounds of 115 grain Winchester and Remington FTP through it without one hiccup.
Just wanted to share this with all the great people here who were good enough to share all the excellent information in this forum.
Scott
Been to cold shoot outdoors the last two weeks.
I read over the prep threads and noticed I was getting the hang up on the magazine follower when inserting the spring and follower. Sanded it with some 600 grit as described in the prep thread.
Field stripped it, cleaned and lubed it per instructions. I also racked the slide at least a couple hundred times to help break in the spring.
So today the Sun was shining and it got to 34 degrees and we plowed out the snow so we could get to our range.
I put 150 rounds of 115 grain Winchester and Remington FTP through it without one hiccup.
Just wanted to share this with all the great people here who were good enough to share all the excellent information in this forum.
Scott