Modified Stock CM9 Sight - Cheap and Easy

[gmcjetpilot]

I am not a fan of the stock sight, the big white strip on the back, wide

front sight. I would have a nice group at 7 yards, but all low at the 6
O'clock consistently (even on a bench rest).


Front sight - Shaved down in height and width to get the aim point up. I did not like how wide the sight was either. First time on range, bulls eye.


Back sight - I covered the stock white stripe with Sharpie, used epoxy to fill in the flying wing groves. Then used black sharpie and white paint pen to make new marks.


It's a work in progress. I am going to keep adjusting. Once I am happy, then I'll sand it all down and use flat black paint. I will make a stencil to make white dots on back sight and front sight verses squares.

Stock:
http://www.handgunsmag.com/files/2011/11/Kahr-CM9-2.jpg

Modified:
http://imageshack.com/a/img823/3981/hpz1.png

[Tilos]

Nice
I simply removed the rear site, turned it around, and re-installed it with the white strip/stripe on the front:yo:
:D

[gmcjetpilot]

Nice
I simply removed the rear site, turned it around, and re-installed it with the white strip/stripe on the front:yo:
:D

oh now you tell me! Ha ha (good idea)

[gmcjetpilot]

Nice
I simply removed the rear site, turned it around, and re-installed it with the white strip/stripe on the front:yo:
:D

Oh now you tell me! Ha ha (good idea)

[CharlieR]

I like it !!

[iflyem1]

Hey that looks pretty good! I too like the 3 dot sights opposed to the original KAHR sights.

[Harrylee]

Been there done that what I do is remove the rear sight and on the back side use a dremel with a diamond round bit and nerves of steel and maybe another beer carefully put to dots in the sight then I usually steel wool clean and reblue then put alittle white lacquer on the tip of a x acto knife and put it into the new holes. Here's the link I did awhile back and the photo is my buddys rear sight I did for him. Now a far as the white bar goes I found out on mine it wasn't paint it was white tape just got under it with a razer and it pulled right off. Glad to still seeing guys put on the thinking cap and try to do things. Your doing good keep it up

http://www.kahrtalk.com/showthread.php?t=16619