Remove the trigger without removing side panel on CM series?

[Sheepdog689]

Can the trigger on a CM9 be removed without removing the side panel on the grip? I just put a new set of Talon grips on my CM9 then decided to have the slide Cerakoted...then decided to do the trigger too. I don't want to ruin the new Talon grips though.

[muggsy]

That Avatar is going to drive old Jocko wild with desire. The short answer is no, but you only need to remove the corner of the grip and then you should be able to get it to stick again using a hair dryer or heat gun.

[Sheepdog689]

OK, thanks

[smokersteve]

I cut the talon grip even with the bottom of the access panel. That way you have access to the triiger. The access area doesn't effect your grip anyway.

[yqtszhj]

Removing the trigger and putting it back on isn't fun. Just sayin. Been there, done that.

[muggsy]

Some guys just have to learn the hard way. It's not that bad if you have less than ten thumbs. :)

[Sheepdog689]

Hmmmm, I think a silver trigger on an all black gun will look vey nice. The silver trigger will coordinate with the silver barrel.:D

[100percent]

Seems like a lot of effort for changing the color of the trigger. Something you can't see with the gun in action.

[jocko]

Can the trigger on a CM9 be removed without removing the side panel on the grip? I just put a new set of Talon grips on my CM9 then decided to have the slide Cerakoted...then decided to do the trigger too. I don't want to ruin the new Talon grips though.

. It is not an easy thing to do and ur doing a cosmetic thing, so WTF. Due the slide if need be but IMO leave that tyrigger area alone. Not to many on this fourm venture intothe triggger area, as basiclly there is nutting u can do in that area to enhance anything but u can certainly fokk thing sup. Just sayin:target::target:

[RevRay]

^^^^ I couldn't have mis-spelled it better myself.

[Sheepdog689]

It's moot at this point.....I took the slide off the CM9 this morning, stripped it out and took it to get Cerakoted (along with the backplate and slide release lever).

The trigger is staying silver, it's not worth the aggravation of pulling it out, actually not worth the effort to put it back in.

If it ever bothers me that much I'll send it back to Kahr and have them install a PM9 trigger in it for me....or take a Sharpie marker and color it in.

[yqtszhj]

....or take a Sharpie marker and color it in.

I've just met my twin. Sharpies and Duct Tape can fix anything. ;)

[Buzzard45]

I've just met my twin. Sharpies and Duct Tape can fix anything. ;)
sometimes a little bailing wire too.:rolleyes: