CM9 Guide Rod

[Joe A.]

My cm9 has lost the end cap on the guide Rod. Has anyone lost their end cap? Would Kahr send me a new cap rod assembly or just a new end cap?

Would there be any problems firing it without the end cap? I have no idea when it came off. I'm sure it has been fired some since it came off.

Thanks.

Joe

[sas PM9]

My cm9 has lost the end cap on the guide Rod. Has anyone lost their end cap? Would Kahr send me a new cap rod assembly or just a new end cap?

Would there be any problems firing it without the end cap? I have no idea when it came off. I'm sure it has been fired some since it came off.

Thanks.

Joe

Joe:

This problem is not common, but also not unheard of.
Probably be best to contact KAHR CS by phone or e-mail to get their take on it.
HTH.

-steve

[jocko]

My cm9 has lost the end cap on the guide Rod. Has anyone lost their end cap? Would Kahr send me a new cap rod assembly or just a new end cap?

Would there be any problems firing it without the end cap? I have no idea when it came off. I'm sure it has been fired some since it came off.

Thanks.

Joe


call kahr or send an email to Jay at kahr, state what happened and they will send u a new reco8l assebly. Save ur old assembly for use of parts later on if needed. that liuttle butto nut should have been locktited on but evidently urs was not. Kahrs does not make or assembly their recoiil assembly, so their vendor is at fault there. Ur not the first, nor willu be the last..

[jcannady]

http://www.kahrtalk.com/showthread.php?t=25599

[Joe A.]

Glad I have backups. Still gonna miss it.