View Full Version : Kahr CM45 WILL NOT EXTRACT UN-FIRED ROUND... FIXED?
vtwingoodies
01-30-2015, 06:40 PM
Hey guys, I found only a vague answer to my problem so I thought that I would post some detail hoping that it might help someone with the same issue.
You will find the full page here... http://vtwingoodies.com/cm45_jam/cm45_jam.html
If someone knows how to embed the linked page, please help yourself.
http://vtwingoodies.com/cm45_jam/1s.jpg
O'Dell
01-30-2015, 08:17 PM
I had the same problem with hollow points when I first got the CM45. About five minutes with a piece of sandpaper solved it quickly. I took very little off the barrel hood.
sas PM9
01-31-2015, 11:28 AM
Hey guys, I found only a vague answer to my problem so I thought that I would post some detail hoping that it might help someone with the same issue.
You will find the full page here... http://vtwingoodies.com/cm45_jam/cm45_jam.html
If someone knows how to embed the linked page, please help yourself.
http://vtwingoodies.com/cm45_jam/1s.jpg
VT:
Excellent write up in the included link.
This issue has been discussed before; some cartridges are a little longer than others and are problematic, but your pictures and gunsmithing on the hood and the slide edge beveling shows a good understanding of the mechanics/physics involved in the ejection pattern problem solving.
Thanks; very impressive for a first post. And welcome to the forum.
-steve
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.