New pm9 barrel question

[mtatbt2008]

Is this typical wear after 300 rounds on a new pm9. The corners of the top of the barrel hood seem to be shaving. Emailed kahr 3 times since last Thursday and haven’t received response https://uploads.tapatalk-cdn.com/20180711/8b624655aa4745ff42cc0716638ac445.jpg


Sent from my iPhone using Tapatalk

[Bawanna]

That's a common wear area. I'd keep shooting and watch that area. If it continues to get worse or the gun fails to go into battery by a slight amount then it might need attention.

I had one that peened in that area and had to be replaced on a K40. Yours at least what I can see in the picture doesn't look bad enough to be a concern at this point.

[mtatbt2008]

Thanks for the advice it has functioned flawlessly and is my new favorite carry piece. The g43 went back in the safe. Hope it’s just a little break in and parts will mate and it wont peen any further


Sent from my iPhone using Tapatalk

[Bobshouse]

The nickel plating flaking off, basically just cosmetic. Still wish Kahr would be more responsive to emails, sometimes they lack in customer service.

[mtatbt2008]

Not just plating moving metal too


Sent from my iPhone using Tapatalk