View Full Version : Barrel crack, or faulty machining ?
Shakey
11-06-2019, 04:15 PM
Fired 610 rounds of factory 110 grain Aguilla andd PPU ammo through a new Kahr/AO carbine. Noticed a crack (?), or poor machining (?) on the barrel where the rectangular piston section transitions to the circular barrel section. Any thoughts? See the photo.
F:\suspected barrel crack edit - 1.jpg
RustyIron
11-07-2019, 07:54 AM
Metallurgist? Machinist?
It's ok that the picture isn't displayed, as I'm fairly confident your barrel is fine.
Shakey
11-08-2019, 03:53 PM
Metallurgist? Machinist?
It's ok that the picture isn't displayed, as I'm fairly confident your barrel is fine.
Thanks for the RustyIron reply.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.