Thompson semi-auto not working

[Rick De Roever]

Have a "Tommy Gun" that won't fire. Replaced the firing pin as someone had activated the bolt with safety on. Still won't fire. Suspect it has to do with cam re: safety. Any ideas out there? RD

[Sgt Saunders]

Are you shure someone put the hammer back in?
I had to ask, it's easy to leave it out........:rolleyes:

[krcochran]

To the Admins: Exactly what happens if you pull the bolt back while the safety is on. I'll have to say that this causes me to want to always leave the safety off, just in case.

[Bawanna]

I wasn't aware that anything happened because the safety was on. I don't play with mine that much but I've not experienced any issue like this.
I may not have been using the safety either as I load and shoot, didn't roll around with it or leave it loaded.

I'll have to look into that some.

[krcochran]

The reason I asked is because the manual clearly states that if you pull the bolt back while the safety is on it could damage the weapon.

[Rudder]

1927 a1 semi auto
Doubles/triples
Firing pin replaced twice, still does it.
Sear beginning to batter
Lever on side of trigger that disconnects sear has gross side play.
Sometimes chambers live round with firing pin forward, jams.
Bolt appears to have excessive verticle play.
Other than throwing parts at it, what is going on here.
Had to replace original firing pin as tip fractured off.
Thanks.
New member.

[Bawanna]

I send an email off to Kahr, doubles/triples is a scary thing. Let them diagnose, probably send it back and get it squared away.