hogue slip-on grip with C/T laser?

[azmxr177]

Will the C/T laser work with a hogue slip-on grip?

[copterdrvr]

I was able to put it UNDER my Keltec P9F and P3at. Keeps it in place and fit just fine.

http://i754.photobucket.com/albums/xx186/copterdrvr/Keltec2.jpg

[jeepster09]

Will the C/T laser work with a hogue slip-on grip?

Yes, may need a little trimming, also install upside[Hogue Jr.] down they fit better.

[mad1ben2]

Agreed, had one on my PF9 with CTL and initially tried it over the laser activation button. It worked for a while (months) and then tightened up enough to drain my laser batteries. Then I got smart and put the laser OVER the slip on grip and it worked like a dream...

[El Jimador]

I prefer mine on top of the CT. I worked the Hogue Handall Jr. up quite high. The tight fit made for a hair-sensitive actuation, so I used a leather hole punch to cut a small hole just over the switch. I really liked the palm swell and tactile feel of the Jr. and with the hole it actuates with just the right amount of presure (ie: if I try I can keep it from acutating and still have a pretty good grip). Like most, I put the Jr. on upside down and trimmed off the excess. This puts the finger groove/ledge at the bottom where I can just lock 2 fingers in tight for a really solid grip. That ended up putting a fair bit of downward presure on the Jr. and after 50 rounds or so it would slip down enough to complicate reloads. I then added an Agrip wrap over the Jr. and couldn't be happier. The PM9 + CT + Jr. + Agrip fills my hand, does not slip, softens percieved recoil, and looks clean. The CT battery compartment is still accessible.

Jim

[PaiN]

Many moons ago, I fit a Hogue Handall Jr. on a PF9 I had with a CT laser. I did cut it to fit.