CW9 Takedown Pin Protrudes

[PCollen]

I was fondling a CW9 today, and I noticed that the end of the takedown pin protruded noticeably from the right side about 1/16th inch, or perhaps a tad more. I would think it should be flush, but perhaps not. Is this normal ? I'm trying to find a 360-deg view of the gun right now to see if it shows it protruding.

[BEARDOG]

It is normal.
It is like that to allow you to have something to push on to remove it for take down. If it was flush you would need a tool to push it through the frame.

[JCP281]

Yea, its so you can use your finger to push it out.

[PCollen]

Thanks..I found the 360-deg tool on the Kahr web site and saw that it was in fact normal. I should have seached harder for the answer before posting the question.

[Cornel]

You may like to see what jocko has done to his piece!

http://kahrtalk.com/showthread.php?t=859

[adventures47129]

I have found this to be a plus when it comes time to break mine down.

[jocko]

I was fondling a CW9 today, and I noticed that the end of the takedown pin protruded noticeably from the right side about 1/16th inch, or perhaps a tad more. I would think it should be flush, but perhaps not. Is this normal ? I'm trying to find a 360-deg view of the gun right now to see if it shows it protruding.

NORMAL:blah: