CM9 Trigger Mod (Cosmetic)

[ATF]

I decided to go with the Kahr PM9 machined slide stop and the black trigger for my new Kahr CM9. So far I have about 500 rounds into the Kahr; no failures! Replacing the trigger was tedious but it can be done in about 1 hour if you have steady hands. My apologies for the picture quality; hopefully you can get the idea...

[Cornel]

Definitively you gave it yourpersonal touch!

[jocko]

ncie work, now just get a 5# striker spring from wolffs andu should have a real dandy.

[GOOFA]

Replacing the trigger was tedious but it can be done in about 1 hour if you have steady hands.

ATF... Did you have any instructions to follow on the trigger change? What was the most difficult task while changing out the trigger? I always heard that its a pita and your better off sending it in to Kahr.

[ATF]

ATF... Did you have any instructions to follow on the trigger change? What was the most difficult task while changing out the trigger? I always heard that its a pita and your better off sending it in to Kahr.

GOOFA: At the time I performed the mod I did not have any instruction so it was a bear. The most tedious task was reassembly; trying to balance the trigger spring and spacer in the proper orientation and concentrically aligned in the frame behind the trigger while properly aligning the trigger bar with the aforementioned components. Since joining kahrtalk earlier this week I did a search for a protocal for disassembly of the frame and found a good link; my apologies I've not yet figured out how to tag:


http://kahrtalk.com/showthread.php?t=4454&highlight=pivot+pin+trigger (http://kahrtalk.com/showthread.php?t=4454&highlight=pivot+pin+trigger)