rogerthedodger
12-24-2009, 05:40 PM
I am detail stripping my CW9. I am trying to do the step 4, insert small tool into the half moon hole, press down the "back extracter pin #27" about 1/16" to allow it to clear the backing plate.
I cannot get the pin to move at all, even if I use a very small allen wrench to push it in, it won't budge at all. What am I doing wrong??
Thank you, Roger
Ok, now I know. It is a VERY STRONG spring, I was afraid to push too hard. I got it out now.
I cannot get the pin to move at all, even if I use a very small allen wrench to push it in, it won't budge at all. What am I doing wrong??
Thank you, Roger
Ok, now I know. It is a VERY STRONG spring, I was afraid to push too hard. I got it out now.