PM45 Slide Stop Issue

[tomstib]

I purchased a used PM45 yesterday. Got a real good deal $500 with nite sights. I took it out today. Very accurate just like my Cw45, Pm9. and newly acquired CW9. After 50 rounds I started to get Failures to Eject. I noticed that the slide stop was just about coming out of the frame. I had a somewhat similiar problem with my CW45 , but that was the slide locking open before the final round and the slide closing on its own after seating in a fresh mag. Kahr took care of the that problem for me because the gun was brand new. Should I contact Kahr for a new slide stop or is this more involved?
Thanks

Tom

[jocko]

two things: It is not a bad slide stop...

go to kahr tech section and hit on GB6491 stickly CW45 FIXES. He addresses that and how to fix it.

Next call kahr and order a new slide stop spring. If the above sticky doesn't guide u through to a fix, then install the new springhy. that is your problem.

[Bawanna]

What he said. It's an easy little tweak. Greg did a great job on that fix thread and theres some good pics of what it should look like and explanations. If that doesn't cure it, the same thread tells ya how to put in the new spring if needed.