PM45 problems

[Southern Guy]

Well I went out today to shoot a little bit and then do a good cleaning but in the first mag I had a new problem. I shot a couple rounds then I pulled the trigger and.....nothing. The trigger had never reset, no resistance. I pulled back the slide an inch or so released, pulled the trigger, and....bang. What the heck??
The next mag it did it twice, so not knowing what to do I proceed to cleaning. After a good cleaning and fresh lube it now does it after every shot. I chamber a round, it shoots chambers another round and... nothing. Then I pull the slide back a bit, release and then bang. At which point it will chamber another round and... you guessed it, nothing.
I cannot get this to happen when dry firing, and every time I manually release the slide it will go bang, it just does this cycling from recoil.


I have absolutely no idea what could be causing this. Any ideas?

[jocko]

is the slide fully closing, If it is the slightet big not into full battery this will happen??. Soundslike the gun is out of time but not sure there is a cure for it other than going back to kahr..

[Southern Guy]

As best as I can tell the slide is going back fully into battery. I'll shoot a it a little more just to double check, but I feel sure it is.
This gun has been to C&S so I doubt KAHR would touch it. I'll probably give C&S a call tomorrow and go from there, since there doesn't seem to be anything I can do. I hate say it but this was a better gun before it went to C&S.

[jocko]

As best as I can tell the slide is going back fully into battery. I'll shoot a it a little more just to double check, but I feel sure it is.
This gun has been to C&S so I doubt KAHR would touch it. I'll probably give C&S a call tomorrow and go from there, since there doesn't seem to be anything I can do. I hate say it but this was a better gun before it went to C&S.

C & S have it back to make it right. I do agree with u. they did about a grands worth of sh-t to my PM9 and I had to send it back to them twice as they never put it back togetherRIGHT and even the second time back they screwed it up. I was very unhappy with the "quality" of the work that they are supposably known for. Personally I wasted a grand on their work to. Call them and they will give u their fed x number to send it back.

Being kahr shows C k& S guns on thier webb site etc, I would think they wouldwarranty any of their work to, but if it worked right whe u sent it to them, then C & S messed up, not kahr..