340pd
10-31-2011, 06:33 PM
Here is something the Garretts made for me. I had an issue with the holster top riding too far below my beltline makeing reholster more difficult than need be. I modified the clip and just used the center hole and the lower one, thus raising the holster about 1/2 inch making it fit perfect. Ron and or Sheryl found out about my issue and made a new clip that uses both standard holes yet does not stick down below the holster. This is hard to describe but the pictures will help. They hit it right on the head.
Three clips. one I modified, one standard and one new that lowers the holster but does not drop below the holster causing it to print.
http://i163.photobucket.com/albums/t320/gnystrom_photos/three.jpg
Standard clip mounted to raise the holster using the lower and center hole. Note clip hanging down below the holster.
http://i163.photobucket.com/albums/t320/gnystrom_photos/old.jpg
New clip lets me use the standalrd mounting holes and keeps the clip even with the bottom of the holster. Perfect. These guys are good.
http://i163.photobucket.com/albums/t320/gnystrom_photos/new.jpg
Three clips. one I modified, one standard and one new that lowers the holster but does not drop below the holster causing it to print.
http://i163.photobucket.com/albums/t320/gnystrom_photos/three.jpg
Standard clip mounted to raise the holster using the lower and center hole. Note clip hanging down below the holster.
http://i163.photobucket.com/albums/t320/gnystrom_photos/old.jpg
New clip lets me use the standalrd mounting holes and keeps the clip even with the bottom of the holster. Perfect. These guys are good.
http://i163.photobucket.com/albums/t320/gnystrom_photos/new.jpg