Can someone help me with a Kahr P380 problem. On reassembly the slide was stopped by the trigger bar (out of position?). The trigger bar rests almost even with the top of the frame. Maybe I need to push harder, but it wasn't a problem on 10 previous occasions when I disassemble/reassembled. I can use a small screw driver to depress the spring loaded trigger bar to pass under the contact point on the frame to reassemble, but again I never had to do that before.

The top of the trigger bar itself is rough and abraded at the top forward edge where the bend is located. The link below will take you to the photos, I hope it works. You may need to 'unzip' the photo(s) to view the pics http://www.dropbox.com/s/rtct5sspmy6...0pics.zip?dl=0